Upgrade Fail
If you don’t see “Firmware upgrade OK” in the “Status Messages” window, it means the utility has failed to complete the firmware successfully. If that occurs, please do the following:
Step 1
Unplug the power cord from the LCD KVM. Then, connect the provided firmware upgrade cable to the firmware upgrade port of the LCD KVM and the serial port of your computer.
Step 3
Repeat the firmware upgrade process. (Please refer to Firmware Upgrade section)
Step 4
After the firmware upgrade has completed, turn off the LCD KVM. Then unplug the power cord from the LCD KVM after it is reset.
Step 2
Slide the Firmware Upgrade Recovery Switch to the Recover position (slide to the right). Then, connect power cord back to the LCD KVM.
Step 5
Slide the Firmware Upgrade Recovery Switch back to the Normal position (slide to the left). Then, connect power cord back to the LCD KVM.
F/W UPGRADE
NORMAL RECOVER
F/W UPGRADE
NORMAL RECOVER
Final Step
Now the LCD KVM is ready to function again, so you simply reconnect all your computers and console
67 back to the LCD KVM and begin using it.
