SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS (CONTINUED)
ELECTRIC HEAT: The thermostats for the machines covered in this manual are factory set. They should not be adjusted except by an authorized service agent.
CHEMICAL FEEDER EQUIPMENT: Detergent may be introduced into the unit through the removal of the bulkhead plug in the rear of the tub and replacing it with the third party detergent injection fitting. Remove the bulkhead plug in the side of the tub to install the deter- gent concentration probe.
For more information concerning detergent concerns, please refer to the page entitled “Detergent Control”.
Brass Plug
Detergent Connection Point
(Machine rear view)
The 1/8” brass plugs on the incoming plumbing rinse injector may be removed to install rinse aid injection fittings.
Brass Plugs
All wires for the chemical injectors should be routed through one of the extra openings in the back of the control box.
Terminals in the control box marked “CVS” provide a constant voltage signal whenever the drive motor is operating.
Terminals in the control box marked “DET” provide a voltage signal whenever the wash motor is operating.
Connection Points
Issued: 05-02-2006 Revised: N/A
32