Suction Cover/Strainer Maintenance
Clean the suction cover/strainer of hair and debris when necessary. To do this, remove the center screw and detach the square cover. Clean the cover by backflush- ing debris from the holes. Replace the suction cover immediately after cleaning. When reinstalling, orient the cover/strainer with the small notch at the bottom. The gasket must be inserted into the groove of the cover/ strainer before reinstalling onto the suction fitting.
CAUTION: Keep hair a minimum of 6 inches away from the suction fitting at all times when the whirl- pool system is operating. Hair longer than shoulder length should be secured close to the head, or a bathing cap should be worn. Do not operate the whirlpool system with the suction cover removed! It is a safety device and must always be in place on the suction fitting to minimize the potential hazard of hair and body entrapment.
SUCTION COVER/STRAINER ASSEMBLY
COVER STRAINER
SUCTION
FITTING
SCREW
NOTCHGASKET
DOME CLEANING
For routine cleaning of the dome, use a mild liquid detergent. Do not use cleaners containing abra- sives, alcohol, ammonia or other solvents.
25
