J-Allure
Skirt Installation
It is necessary to mount the skirt shell clips on the factory installed wood blocks located along the underside of the rim. Mark hole locations on the blocks using clips as a template for correct hole spacing. Then drill a pilot hole 1/2" deep using a 3/32" diameter drill. Use caution to avoid drilling through the bath rim. Secure the clips to the wooden blocks as shown.
SHELL
SHELL CLIP 1/4"
Using a square or level, determine the location of the vertical drop from the bath rim at both ends and the center of the bath. Locate the center wood block (provided) at the appropriate distance from the vertical drop, centering it lengthwise with relation to the rim of the bath. The faces of the side blocks (provided) will be oriented along a line from the center vertical drop point to the end vertical drop point. The blocks can be screwed, nailed or adhered with adhesive to the floor. Make sure the finished sides of blocks are outward. Glue the skirt blade
Before attaching skirt, locate the CD/radio speaker and power connectors coiled under the bath rim. Uncoil and connect the speaker and power connectors to the CD/radio. Also locate the green ground wire and connect to the chassis of the CD /radio.
Slip the skirt up between the rim and the shell clips. While holding the skirt at the bottom, move it inward toward the bath. Lift it up so there is 1/2" gap between the floor and the bottom of the skirt. While using shims to hold the skirt up, attach the skirt to the skirt blade and wooden blocks with screws through the predrilled holes.
USING A SQUARE OR LEVEL, MARK THE PERIMETER OF THE BATH ON TH FLOOR
| WALL |
7/8" | |
| SKIRT BLADE |
2" | |
FINISHED SIDE | |
OF BLOCK | |
BATH PERIMETER
SKIRT
SHELL CLIP
SKIRT BLADE
SCREW |
| |
WITH |
| |
HINGED | NOTE: SAME LEVEL | |
CAP | ||
AS FINISHED FLOOR | ||
FINISHED | ||
| ||
FLOOR | ||
1/2" | WOOD BLOCK | |
SPEAKER POWER |
| |
CONNECTORS |
|
8
