OPERATION
B. 30 MINUTE TEMPERATURE CONTROL
The 30 minute temperature control features a 30 minute press on timer lighting up the word "STEAM" and a thermostatic control preset to reach 120 degrees Fahrenheit. The digital control can be mounted either inside or outside the steam room. The preset temperature can be adjusted in a range between 100 degrees and 125 degrees Fahrenheit. Once the set temperature is reached the ''soft steam'' feature automatically engages cutting steam production back to a single element to provide softer billowing steam during more of the steam bath. If the steam room temperature drops more than 5 degrees both elements will automatically engage.
Operation of Your 30 Minute Temperature Control
1.Be sure the power circuit and water supply to the generator are on.
2.Firmly press the ON/OFF button on the control until the word “STEAM” lights up.
3.The generator should produce steam in 5 to 10 minutes and will turn off automatically in 30 minutes. You may also press the control a second time to turn off the “STEAM” light and shut down the generator.
4.If you wish to change the preset temperature see the instructions in below.
Temperature Adjustment
1.To adjust the set temperature remove the
2.Using a small slotted screw driver turn the adjustment pot in the desired direction. See diagram. One quarter turn equals approximately 5 degrees of temperature change. Caution: Over stressing the adjustment pot can damage the control.
3.Snap the control cover plate back on by sliding the top of the cover plate onto the control housing and pushing on the bottom of the control cover plate. See diagram. The new temperature setting will become effective the next time the steam is turned on.
WALL
DECORATIVE CONTROL
COVER PLATE
2 | CONTROL |
HOUSING |
13
