Janome 4800 manual Changing Needles, To Attach and Remove the Presser Foot

[1][2]

12

3

[3]

[1][2]

3

2

1

[1][2]

12

3

14

Changing Needles

[1]Raise the needle by pressing the Up/down needle position key and lower the presser foot.

Turn off the power switch.

Loosen the needle clamp screw by turning it counterclockwise.

Remove the needle from the clamp.

[2]Insert the new needle into the needle clamp with the flat side to the rear.

When inserting the needle into the clamp, push it up as far as it will go. Tighten the clamp screw firmly by turning it clockwise.

[3]To check for a good needle, put the flat side of the needle onto something flat (the needle plate, glass etc.).

The gap between the needle and the flat surface should be consistent. Never use a bent or blunt needle.

1 Needle clamp screw

2 Pin

3 Needle clamp

To Attach and Remove the Presser Foot

[1]Press the red button on the back of the foot holder. The presser foot will drop off.

[2]Place the selected presser foot so the pin on the foot lies just under the groove of the foot holder.

Lower the presser bar to lock the foot in place.

1 Red button

2 Groove

3 Pin

To Remove and Attach the Foot Holder

[1]To Remove:

Remove the thumb screw by turning the screw counterclockwise with the screwdriver.

[2]To Attach:

Match the hole in the foot holder with the threaded hole in the presser bar.

Fit the thumb screw into the hole. Tighten the screw by turning it clockwise.

1 Thumb screw

2 Foot holder

3 Presser bar