Janome 4800 manual Darning, For darning less than 2 cm, To memorize darning stitches

12

3

	3
1	2	4

[1][2][3]2

[4]

5

6

2

7
	8	9	10

Darning

1	Stitch pattern:	22
2	Presser foot:	Automatic buttonhole foot R
3	Darning shape:	(See below for settings.)

•To sew:

[1]Pull the button holder to the rear.

[2]Place the garment under the foot. Press the Up/down needle button twice. Raise the foot.

Remove the fabric to the left to draw both threads under the foot and put the fabric back under the foot.

[3]Lower the foot. Press down the foot control. The machine will lock stitch, sew 16 rows of darning, lock

stitch again and the machine will stop automatically.

*The size of one darn cycle is variable. However, the maximum stitch length is 2 cm (3/4”) and the maxi-

mum stitch width is 7 mm (9/32”).

[4]Turn the fabric and repeat sewing for reinforcement. 1 Button holder

2 Starting point

3 2 cm (3/4”)

4 0.7 cm (9/32”)

•For darning less than 2 cm

Switch to “Low” speed setting. 4 lock stitches will be sewn first. Then sew to the desired length and press the reverse button. The desired length has now been determined.

Continue sewing until the machine stops automatically.

5Reverse button

6Desired stitch length

•To memorize darning stitches

When repeatedly sewing the same-size darn to repair a side rip or belt loop, press “Memory” key and restart sew- ing.

•Adjusting the shape of darning stitches

If one side of the darn is higher than the other, make them even by pressing the stitch length “+” or “-” key.

When you press the “+” or “-” key, d3 will be indicated automatically.

You can adjust the shape of the darn by pressing “+” or “-” key, d1 to d5.

7When the left side is lower

8Select “d1” or “d2” to balance the stitches.

9When the right side is lower.

10Select “d4” to “d5” to balance the stitches.

43