Janome 4800 manual Winding the bobbin

	[4]“C”		[5]
3	[2]	“A”	1
	[3]
5	“B”
4
7			6
6			[1]

[6]		• Winding the bobbin
	2	For the bobbin winding, set the speed control lever at
		the medium to high speed position.
		[1]	Hold the end of thread.
		[2]	Guide the thread through the thread guide “A”.
		[3]	Thread the thread guide “B”.
		[4]	Thread the thread guide “C”.
		[5]	Thread through the hole in the bobbin from the
			inside to the outside.
[7]			1 Bobbin winder spindle
		[6]	Put the bobbin on the bobbin winder spindle, and
			push it to the right.
			2 Bobbin winder stopper
		[7]	Hold the free end of the thread in your hand and
			depress the foot control.
			Stop the machine when it has made a few turns,
			and cut the thread close to the hole in the bobbin.
			Depress the foot control again.
			When the bobbin is fully wound, it will stop
			automatiaclly.
,		,	Return the bobbin winder to its original position by
			moving the spindle to the left, and cut the thread as
			shown.
		*	The machine will not sew until the spindle is in the
			left position.
		*	You can also use the additional spool pin for the
			bobbin winding as shown.
			3 Spool
			4	Additional spool pin
			5	Felt
			6	Additional spool pin hole
			7 Spool base

17