Jasco RM94927, RM24927 instruction manual Programming For Audio, Vol Audio Code Cd Rcvr Ld

Programming For Audio

This remote control will operate many fea- tures found in audio/video receivers. The remote control is already programmed to operate most GE, RCA and ProScan brand A/V receivers. Other brands of receivers need to be set-up under the AUDIO button prior to using the device.

1.Manually turn on the device you wish to control. Find the three digit code for the device you wish to control in the code list below.

2.Press and hold the CODE SEARCH button until the INDICATOR LIGHT lights, then release the CODE SEARCH button.

3.Press and release the AUDIO button (The

INDICATOR LIGHT will blink then remain lit.

4.Enter the code using the Number Buttons. After your code is entered, the INDICA- TOR LIGHT will turn off. If the code is not valid, the INDICATOR LIGHT will blink. Check the code list and repeat process.

5.Aim the remote at the device you wish to control and press the ON•OFF button. The device should turn off.

CODE

SEARCH

INDICATOR

			LIGHT
	AUDIO
			(BLINK)
1	2	3
4	5	6
7	8	9	(OFF)
	0
		ON•OFF

VOL

AUDIO CODE

CD RCVR LD

6. With your device

on, press VOL+ (Volume up). If the device responds, no further programming is required.

NOTE: If your device does not respond, try all the codes for your brand. If the codes do not work, or your brand is not listed, try the Code Search method.

7. Enter your code and the type of device

10