Backlighting
Backlight illumination is only activated when you press the LIGHTkey on the rubber key-
pad. Pressing the LIGHTkey will also activate the LCD touchscreen display. After you
press theLIGHT key, the backlighting remains on for 30 seconds, (or however long the
LCD Touchscreen Display Time is set to), if no other commands are given.
If a command is entered after the LIGHTkey has been pressed, the Backlight illumination
continues for a further 30 seconds after the command is completed. Once the Backlight
time has run out, the Backlight does not re-activate until the LIGHTkey is pressed again. If
the Backlight illumination is on, and the LIGHT key is pressed again, the Backlight turns
off.
Master ResetAMaster Reset returns all the RM24941 defaults back to the original factory settings. The
Master Reset clears all customer-programmed codes, Learned commands , and resets all
key labels.
To perform a Master Reset, follow these steps:
1. Press and hold the SETUP key on the rubber keypad until the LED indicator light
remains on and the touchscreen shows the Main Setup Screen. This process takes
approximately 2-3 seconds.
2. Release the SETUPkey.
3. Press and hold the SETUPkey again for approximately 5 seconds until the LED indica-
tor light turns off.
4. The default reset is now complete and the remote is in normal TV Mode (screen is
blank).
All Power Off FeatureThe All Power Off feature is available in all normal operating modes. If the ON•OFFkey
on the rubber keypad is pressed twice consecutively (within two seconds), all RCAequip-
ment is turned off.
15
24941manual 8/13/03 8/19/03 8:42 AM Page 17