Jenn-Air 720-0511 Using The Side Burner, Care & Maintenance Of Side Burner, Lighting Instructions

Models: G18Y07P-02

1 34
Download 34 pages 5.77 Kb
Page 23
Image 23
USING THE SIDE BURNER

USING THE SIDE BURNER

Inspect the gas supply hose prior to turning on the gas. If there is evidence of cuts, wear or abrasion, it must be replaced prior to use. Do not use the side burner if gas odor is present.

LIGHTING INSTRUCTIONS WARNING

When lighting, always keep your face and body as far away from the burner as possible.

LIGHTING INSTRUCTIONS

1.Open the top cover or lid. Remove any cooking utensils that are near the burner grate.

2.Turn the control knob counterclockwise to the “HI” setting and then push the control knob in. You should hear a “clicking” sound if the electronic ignition system is working properly.

3.If the burner does not light within 4 seconds, turn the control knob to the “OFF” position.

4.If the smell of gas is detected and the igniter is not functioning, immediately turn the control knob to the “OFF” position.

5.Allow 5 minutes for any accumulated gas to dissipate. If the side burner igniter will not function, follow the match lighting instructions below.

MATCH LIGHTING

1.Insert a match into the lighting rod. Ignite the match and place near the side burner ports.

2.Turn the control knob counterclockwise to the “HI” setting. The side burner should light immediately.

3.Rotate the control knob to the desired setting.

CARE & MAINTENANCE OF SIDE BURNER MATCH LIGHTINGCARE & MAINTENANCE OF SIDE BURNER

BURNER CLEANING

Clean the exterior of the burner with a wire brush. Clear any clogged burner ports with a straightened paper clip. Never enlarge the burner ports. Never use a wooden toothpick as it may break off and clog the port.

SIDE BURNER GRATE

The top burner grate is stainless steel. To avoid burns, do not clean the grates while they are hot. While in place, they may be washed with hot, soapy water, rinsed and wiped dry. Never immerse hot grates in water.

STAINLESS STEEL

There are many stainless steel cleaners available. Always use the mildest cleaning procedure first, scrubbing in the direction of the grain. Do not use steel wool as it will scratch the surface.

To touch up noticeable scratches in the stainless steel, sand very lightly with dry 100 grit sand paper in the direction of the grain.

21

Page 23
Image 23
Jenn-Air 720-0511 manual Using The Side Burner, Care & Maintenance Of Side Burner, Lighting Instructions, Match Lighting