• | • | • | • | • | • | • | • | • | • | • | • | • | • | • | • | • | • | • | • | • | • |
Leveling Legs
The range should be leveled when installed. If the range is not level, turn the plastic leveling
legs, located at each corner of the range, until range is level,
LEVEL_NGLEG
Oven Bottom
Protect oven bottom against spillovers, especially acid or
sugary spills, astheymaydiscolortheporcelainenamel. Use the correct pan size to avoid spillovers and boilovers. Do not place aluminum foil directly on the oven bottom.
The oven bottom on a conventional bake range may be removed for easier cleaning. NOTE: The oven bottom on
convection models is not removable. | _ | |
To remove: When cool, re- | r |
|
move the oven racks. Slide |
| |
the two catches, located at | [[_J[ | 2"_ "'_/_q |
each rear comer of the oven | H_¢£_//_ |
|
bottom, toward the front of | _11_¢_ | - |
the oven. | T4/ | - |
Lift the rear edge of the oven | II_/Ji | t 3 i |
bottom slightly, then slide it | _" |
|
back until the front edge of the oven bottom clears the oven front frame. Remove oven bottom from oven.
To replace: Fit the front edge of the oven bottom into the oven front frame. Lower the rear of the ovenbottom and slide the two catches back to lock the oven bottom in place,
Electrical Connection
Appliances which require electrical | /._. | ] | |
power are equipped with a | _ | I | |
groundingplugwhichmustbeplugged | _f_/_l | (1__ | I |
| L | I | |
hole 120 volt electrical outlet. | I i | _ |
|
Always disconnect power to appliance before servicing.
Maintenance 24
• • • • • • • • • • • • • • • • • • •
The
GROUNDING PRONG FROM THE POWER CORD PLUG.
If an ungrounded,
How to Remove Range for Cleaning and Servicing
Follow these procedures to remove appliance for cleaning or
servicing:
1.Shut off gas supply to appliance.
2.Disconnect electrical supply to appliance, if equipped.
3.Disconnect gas supply tubing to appliance.
4.Slide range forward to disengage range from the
5.Reverse procedure to reinstall. If gas line has been discon- nected, check for gas leaks after reconnection. NOTE: A qualified servicer should disconnect and reconnect the gas
supply.
6. To prevent range from accidentally tipping, range must be secured to the floor by sliding rear leveling leg into the
Proportional Valve Adjustment
for Surface Burners
The Lo setting should produce a stable flame when turning the knob from Hi to Lo. The flame
should be 1/8 inch or lower and must be stable on all ports on Lo setting.
To adjust: Operate burner on Hi for about five minutes to preheat
burner cap. Turn knob back to Lo; remove knob, and insert a
flame size by turning adjustment screw in either direction, small screwdriver into the center of the valve stem. Adjust the
while holding the stem.
Flame must be of sufficient size to be stable on all burner
p°rts' Ifflame adjustment is needed' adjust ONLY °n the L° setting. Never adjust flame size on a higher setting.
NOTE: All gas adjustments should be done by a qualified servicer only.
