Jenoptik 5.0z3 manual Appendix, Troubleshooting, Problem Cause Solution

APPENDIX

APPENDIX

TROUBLESHOOTING

Problem	Cause	Solution
	Battery is inserted in the wrong	Reload battery in the correct direction.
	direction.
Power does not turn
	Batteries are dead.	Replace or recharge batteries.
on.
	The battery compartment door	Make sure the battery compartment door
	is open.	is securely closed.
	The flash is charging.	Wait for the flash to charge.
The camera does not
	Memory is full.	Insert a new memory card.
take pictures.
	Memory card is not formatted	The card may be detective, use a new
	correctly.	card.
Image is not recorded	The Flash is charge.	Wait for the flash to charge.
when the shutter
	Memory is full.	Insert a new memory card.
button is pressed.
The flash does not	Flash is set to OFF.	Set the flash to any mode except off.
fire
	The camera was moving when	Hold the camera steady when shooting
	the image was captured.	picture.
Image is blurry or out
	The subject was beyond the	Turn the Macro mode on it the subject is
of focus.
		within 5 cm (zoom out) or 50 cm (zoom
	range within which the camera
		in). Do not use Macro mode when
	can focus.
		shooting distant subjects.
Image is not	A memory card with non-DCIF	This camera cannot display non-DCIF
displayed on the LCD	images (recorded with other
		images.
monitor.	camera) is loaded.
Recorded images are	The camera was turned	If the battery low indicator appears on
	off/powered down before the	the LCD monitor, replace the battery
not saved in memory.
	image was stored in memory.	immediately.
Cannot transfer		Install the USB driver before you
images to a computer
	USB driver is not installed.	connect the camera to a computer / turn
after connecting the
		the camera on.
USB cable.

41