®
CR560X
Test Speaker Connections
These tests make sure the speakers are connected right. If speakers don’t play at all, both wires may not be connected. If the wrong speaker plays (you hear front speakers when you expect rear speakers) make sure you connected the wires right.
Balance
Fader
1 SEL SEL
SEL SEL
2VOL +
3 SEL SEL
SEL SEL
4
VOL –
1.Press SEL four times.
2.Hold the + button until the display shows BA.r 10.
Only the right speakers should be playing.
If not, check the wiring. Make sure you connected the wires just like the chart on page 6.
3.Press SEL four times again.
4.Hold the – button until the display shows BA.L 10.
Only the left speakers should be playing.
If not, check the wiring. Make sure you connected the wires just like the chart on page 6.
5 SEL SEL
SEL SEL
SEL
6VOL +
7 SEL SEL
SEL SEL
SEL
8
VOL –
5.Press SEL five times.
6.Hold the + button until the display shows FA.F 10.
Only the front speakers should be playing.
If not, check the wiring. Make sure you connected the wires just like the chart on page 6.
7.Press SEL five times again.
8.Hold the – button until the display shows FA.r 10.
Only the rear speakers should be playing.
If not, check the wiring. Make sure you connected the wires just like the chart on page 6.
Once everything is operating correctly, perform Final Installation on page 10.
9
5588 CR560X_EIN.p65 | 9 | 2/29/00, 10:46 PM |
