®
CR560X
Installation
Before You Begin Installation
Before you begin, you will need tools, supplies and adapters. It is best to make sure you have everything you need before you take your dashboard apart.
Tools and Supplies Needed
Basic Installation:
•Flat and Phillips screwdrivers
•Wire cutter
•Wire stripper
•Tools to remove existing radio (screw- driver, socket wrench set or other tools)
•Radio removal tool
•Electrical tape
Advanced Installation:
•Soldering iron
•Crimping tool
•Volt meter or 12 volt test light
•Solder
•Crimp connectors
•
•Speaker wire
Adapters for Easier Installation
Electrical and dashboard adapters make installation easier. Purchase adapters from your local Jensen retailer, electronics store or car stereo specialty store.
Wiring Harness Adapter
For a basic installation, you can purchase a wiring harness adapter for your car's existing radio connectors. This makes installation easy.
Dashboard Adapters
The opening in your dashboard may not match the size of your Jensen radio. Purchase an adapter kit for your car.
Antenna Adapter (GM cars)
1990 and newer GM cars have a small antenna connector. You will need an adapter when installing this radio in a newer GM car.
Speaker Requirements
Only connect the CR560X to speakers rated in the load impedance range of 4 to 8 ohms. Speakers with a load impedance less than 4 ohms could damage the CR560X.
2
5588 CR560X_EIN.p65 | 2 | 2/29/00, 10:46 PM |