®
CR560X
✓Testing
Before you finish the installation, you should do the following tests to make sure the wiring is correct and everything is operating properly.
Reconnect Battery | Test Memory Wiring |
When wiring is complete, |
|
reconnect the battery |
|
negative terminal. | + |
| — |
Test Power Wiring
1.Turn ignition switch on. Press the (Power) button to turn the radio on. The display should light and show the radio display. If not, check the electrical connection at the yellow and red wires.
2.If equipped, the power antenna should also operate. If not, check electrical connections to the dark blue wire.
Test Antenna Connection
1 | 1 | 1. With the radio playing, hold |
| button 1 for two seconds. | |
|
|
CH 1 will appear on the display. You just stored the current station in memory.
2.Turn the key off, then turn the key on again.
2
3.The radio should resume playing at the same station
and volume. If not, make sure the yellow wire is connected properly.
Set the Clock
Press DISP button to display the clock.
1 | DISP | 1. | Press DISP button for |
| |||
|
|
| three seconds until |
|
|
| display flashes. |
|
| 2. | Press to change |
1
1. Hold a tuning button |
for more than two |
minutes, to change |
2
or
VOL +
seconds. The radio |
should tune to a |
nearby station. If |
not, check antenna |
connection. |
2. Press + to increase |
volume until you |
can hear the radio |
playing. |
hours. |
2
M H
8
5588 CR560X_EIN.p65 | 8 | 2/29/00, 10:46 PM |