VM9215BT

System Reset

 

To correct a system halt or other illegal operation,

[RESET] Button

use the tip of a pen to press the reset button

 

located on the front bottom-right corner of the unit.

 

After a system reset, the unit restores all factory default settings.

NOTE: If the unit is reset while a DVD is playing, the DVD resumes play once the reset is complete.

Image/Display Settings

Video Output Modes

Table 5 shows the video output mode for each playing source.

 

Table 5: Video Output Modes

Playing Source

 

Video Output Modes

AM/FM TUNER

 

YCbCr Mode

DVD

 

YCbCr Mode

AUX IN

 

CVBS Mode

*CVBS – Composite Video Baseband Signal

Picture Adjustment

To adjust monitor display settings, perform the following steps:

1.Press the PIC button on the monitor to display the picture adjustment menu. The “BRIGHT” bar is highlighted in yellow.

2.Turn the rotary encoder to adjust the brightness setting level.

3.Press the PIC button again. The “CONTRAST” bar is highlighted in yellow.

4.Turn the rotary encoder to adjust the contrast setting level.

5.Press the PIC button again to exit the picture adjustment menu.

Parking Brake Inhibit

When the pink “Parking” wire is connected to the vehicle Parking Brake circuit, the front TFT monitor will display video when the Parking Brake is engaged. (When the pink wire is grounded via the Parking Brake circuit, video will be displayed.)

24

Page 24
Image 24
Jensen VM9215BT System Reset, Image/Display Settings, Parking Brake Inhibit, Video Output Modes, Picture Adjustment