Assembling the Saw to the Stand
Do not plug the table saw into the power source until all assembly has been completed! Failure to comply may cause serious injury!
1.Turn the stand upside down and place onto the table saw (Figure 3)
Note: The side with the JET logo (A) is the front side of the stand and will be on the same side as the Warning label (B) on the table saw.
Line up the holes in the top plates of the stand with the holes in the table saw (C) so that the front of the stand is flush with the front of the saw. The sides of the stand should also be flush with the sides of the saw.
Figure 3
2.Attach the saw to the stand with four M8x20 hex cap screws, eight M8 flat washers and four M8 hex nuts using Figure 4 as a guide. Tighten the saw to the stand hardware firmly.
3.Turn the table saw right side up. Make sure the saw is sitting level and with a 12mm wrench tighten all stand hardware.
Figure 4
Blade Tilt Pointer
Referring to Figure 5:
Secure the blade tilt pointer (B) on the front of the saw onto the bracket (C) next to the shaft (D) with an M4 screw (A) and tighten with a
Figure 5
12
