Switch Bracket
Referring to Figure 11:
1.Insert two M6x12 pan head screws (A) through the back of the switch bracket mounting holes
(B). Place M6 washers (C) and square nuts (D) on the threaded ends of the screws.
2.Mount the switchbox (C) onto the rail (F) such that the square nuts (A) slide into the groove (E) on the lower back side of the rail.
Tighten screws with a cross point screwdriver.
Extension Wing Adjustment
Referring to Figure 12:
1.Level the left extension wing (B) to the saw table (C) by using a straight edge (A). Start by tightening the three screws (12mm wrench required) under the extension wing (B) that secures it to the table (C). Tighten these just enough to hold the wing in place but loose enough to change the wing height by tapping on it.
2.Use the straight edge (A) to level the inside edge of the extension wing (B) to the table (C). Tighten the three screws that hold the wings
(B) to the table (C).
3.Next bring the straight edge out to the highest point on the outside edge of the wing at the front (A) of the saw. You may have to grab the outside edge of the extension wing and pull up or push down to level. Once the highest point at the front of the saw is located and leveled, tighten the hardware holding the extension wing to the front rail.
4.Move the straight edge (D) to the rear of the same extension wing and repeat this process.
5.Repeat steps 1 – 4 for the right extension wing.
Blade Guard and Splitter
Referring to Figure 13:
1.Through the saw table opening on top, locate two hex nuts (A1) that secure two retaining plates (B) and loosen with a 10mm wrench.
2.Slide the tab of the blade guard splitter (C) between the two retaining plates (B) and onto the threaded mounting studs (D).
Note: The
3.Tighten the hex nuts (A1) enough to hold the tab (C) in place but loose enough to allow for adjustment. You will need to install the blade before the final adjustment.
Figure 11
Figure 12
Figure 13
15
