Front Guide Rail
Referring to Figure 9:
Required Fastening Hardware (see also inset):
A – 6 ea – Square Head Bolt (M8)
B – 6 ea – Lock Washer (M8)
C – 6 ea – Hex Nuts (M8)
Required Tools:
–12mm wrench
1.Place six square head bolts (A) through the mounting holes on the front of the left extension (F), table (G) and right extension (H).
2.Place lock washers (B) and hex nuts (C) on the threaded ends of the bolts protruding through the extensions and table. Just start the hex nuts but do not tighten.
3.Position all six bolts so that approximately 1/4" of thread is visible between the bolt heads and extensions/table (J).
4.Slide the short rail (D) onto the front edge of the extension and table from left to right (K). The back edge of the rail should make contact with the front edge of the extension and table and the square head bolts should slide into the groove on the back side of the rail.
5.In the same manner described in step 4, slide the long rail (E) onto the front edge of the extension and table from right to left (L).
6.Slide the short and long rail sections together so they become one piece. The protruding pins from the short rail should insert into the corresponding openings in the long rail.
7.Position the entire rail assembly so the left end of the rail is about 0.75” in from the edge of the left extension.
8.
Support Rod
Referring to Figure 10:
1.Place the tenon end (A) of the support rod into the slot (B) of the front rail.
2.Secure the tapped and threaded end (C) of the support rod to the rear rail (D) with the M6 flat washer (E) and M6 hex cap screw (F) provided.
14
Figure 9
Figure 10
