During all operations that involve accessibility to internal components the appliance must be unplugged.
Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required.
Therefore make sure, that the counter it is fixed under, is suitably secured to a fixed structure (e.g. adjacent kitchen unit cabinets, wall).
Fixing to the adjacent units
The appliance must be secured against tilting.
Water connection
Water inlet connection
This appliance must be connected to a cold water supply.
For making the connection itself, the coupling nut fitted to the appliance inlet hose is designed to screw onto a 3/4" gas thread spout or to a purpose made
The water pressure must be within the limits given in the ‘Technical data’. Your local Water Authority will advise you on the average mains pressure in your area.
The water inlet hose must not be kinked, crushed, or entangled when it is being connected.
The appliance features inlet and drain hoses which can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks.
If the appliance is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose.
This appliance has been fitted with safety features which will prevent the water used in the appliance from returning back into the drinking water system. This appliance complies with the applicable plumbing regulations.
Caution! Do not use inlet and drain hoses which have previously been used on another appliance.
Water drain connection
The end of the drain hose can be connected in the following ways:
•To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the appliance.
•To a stand pipe provided with venthole, minimum internal diameter 4 cm.
25
