John Lewis JLDW 1221 instruction manual Washing and drying results are not satisfactory

Malfunction	Possible cause	Possible solution
	The delay start is set.	• Cancel the delay start.
		• When the countdown is
		completed, the washing
		programme starts
		automatically.

Once the checks have been carried out, switch on the appliance. The programme continues from the point at which it was interrupted.

If the malfunction occurs again or the display shows an alarm code that is not listed in the table, please contact our extended warranty administrators. Refer to 'Repairs - after sales service'.

The washing and drying results are not satisfactory

The dishes are not clean.	The washing programme was	Make sure that the washing
	not applicable for the type of	programme is applicable for the
	load and soil.	type of load and soil.
	You did not put the items	Put the items correctly in the
	correctly in the baskets, water	baskets.
	did not touch all surfaces.
	The spray arms could not turn	Make sure that an incorrect
	freely. Incorrect position of the	position of the items do not
	items in the baskets.	cause the blockage of the spray
		arms.
	The filters are dirty or not	Make sure that the filters are
	assembled and installed	clean and correctly assembled
	correctly.	and installed.
	The quantity of detergent was	Make sure that the quantity of
	not sufficient or missing.	detergent is sufficient.
Limescale particles on the	The salt container is empty.	Fill the salt container with
dishes.		dishwasher salt.
	Incorrect level of the water	Adjust the water softener with
	softener adjustment.	the correct level.
	The salt container cap is not	Make sure that the salt
	closed correctly.	container cap is closed
		correctly.
There are streaks, whitish	The rinse aid quantity is too	Decrease the rinse aid quantity.
stains, or a bluish layer on	high.
glasses and dishes.
Dry water drop stains on	The rinse aid quantity is too	Increase the rinse aid quantity.
glasses and dishes.	low.

25