flashes 3 times and the message Err is displayed for a few seconds.
Important!
You must set the washing machine to Pause before you make any change in the programme in progress.
Programme correction
As long as the wash programme has not been started yet, the programme selection can still be changed.
If the programme has been started, it is only possible to correct the functions, if the programme is first interrupted by pressing button 10. In this case only some of functions can be selected depending on the programme which is running.
If the wash programme is to be corrected by means of buttons 3, the appliance must first be switched off by pressing the button 2.
Switch on the appliance, set the new programme and press button 10 again. The water remains in the tub.
Cancel a programme or switch the appliance off
If a washing programme that has already started is to be cancelled, press button 2 to RESET the programme. All lights and the display go out and the appliance is switched off. The previously selected programme is now cancelled. Another programme can now be selected.
Important! If any problems occur as the programme runs, always first switch the appliance off by pressing button 2 before a new programme is selected. Consider the temperature to which the washing water may already have been heated. Press the button 10 to interrupt a programme which is running, the corresponding green pilot light starts blinking.
How to interrupt a programme
Press the button 10 to interrupt a programme which is running, the corresponding green pilot light starts blinking.
Press the same button again to restart the programme.
How to open the door during the cycle of a programme
You can open the door, after having set the washing machine to Pause, provided the following conditions exist:
•The washing machine is not in the heating phase
•The level of the water is not high;
If these requirements are met, when you pause the washing machine, the «Door lock» light goes off and the door can be opened.
Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the appliance off by pressing button 2. After a few minutes, you can open the door.
Pay attention to the level and temperature of the water in the washing machine!
16
