Helpful hints and tips, End of programme

When you close the door to restart the programme select the previous programme by pressing the buttons 3, repeat the options previously selected and press the button 10.

End of programme

The pilot light of the button 10 goes out. «0» blinks and the message Wash time disappears from the display. The Door lock pilot light goes out. The door can now be opened and the laundry can be removed. Switch the appliance off by pressing button

2, before removing the laundry. If the Rinse Hold or Quiet option has been selected the Door lock pilot light is on. The button 10 pilot light goes out and the display shows a blinking «0». The door cannot be opened because the water must be drained.

To empty out the water there are 2 possibilities:

1.Select the draining programme and press the button 10: the water is emptied out without spinning.

Stand by: once the programme has finished after a few minutes the energy saving system is enabled with the pilot lights switched on. By pressing any button the appliance will come out of the energy saving status.

2.Select the spinning programme. Select the spin speed by pressing the relevant

button and then press the button 10. The water is emptied out and the laundry is spun at the selected spin speed. Reduce the spin speed if needed, by pressing the relevant button.

Switch the appliance off by pressing button 2.

Remove the laundry from the drum. Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e.g. by shrinking) or bleed colour into another load of laundry.

If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.