Jotul GF300 BV manual When installing at an altitude above 2000’ the, hood

• When 6” diameter decorative pipe is installed to

cover the venting any Listed Flexible Gas liner must

Venting through a Masonry or Prefabricated Manufactured Chimney

be connected directly to the stove’s draft hood.

• Use of single wall connector pipe as a vent is

prohibited for use with the GF300 Allagash B-Vent

stove.

• A firestop is required at every floor.

• Any venting that is exposed above the first floor,

regardless of attic space or living space, must be

enclosed. Always maintain the required clearance

from all sides of the vertical vent system according

to manufacture.

Top sealing achor plate

Type B vent or

Listed Flexible Gas

Liner.

Storm collar required

Listed

termination cap required

• Installation of any components not manufactured or

approved by Jøtul or failure to meet all clearance

requirements will void all warranties and could result

in property damage, bodily injury, or serious fire.

• Never modify any venting component, or use any

damaged venting product.

• THE GAS APPLIANCE AND VENT SYSTEM MUST BE

VENTED DIRECTLY TO THE OUTSIDE OF THE BUILD-

ING, AND NEVER ATTACHED TO A CHIMNEY SERV-

ING A SOLID FUEL OR GAS BURNING APPLIANCES.

• BE SURE TO MAINTAIN THE PROPER CLEARANCES TO

COMBUSTIBLES AS DEFINED IN THIS MANUAL AND

IN THE INSTRUCTIONS PROVIDED WITH EACH

VENTING COMPONENT.

• When installing at an altitude above 2000’ the

minimum vertical rise becomes 12’ from the draft

hood.

NOTE:

A chimney system located outside the building envelope may be subject to downdrafting and/or flow reversal. Atmospherically-vented appliances, such as B-Vents, may not be compat- ible with these chimney systems.

All atmospherically-vented appliances (B-Vents) are affected by atmospheric conditions and house pressurization. For example, a B-Vent appliance vented to an outside chimney system in a basement will likely be subject to negative pressure. This type of installation is not recom- mended.

Use of Type B vent liner within outside chimneys is recommended to help keep the gases warm and stabilize draft.

Max. Height 35 ft. Min. Height 7 ft.

Always

maintain the

proper

clearance to mantel and trim

Maximum offset is 4 ft.

Recommended

damper sealing plate to seal flue chamber to prevent heat loss

WARNING: FAILURE TO POSITION THE PARTS IN ACCORDANCE WITH THIS DIAGRAM OR FAILURE TO USE ONLY PARTS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.

Figure 6. GF 300 BV venting through a masonry chimney.

9