Optional Antique Brick Kit
# 155648
CAUTION!
THE BRICK PANELS AND LOG PARTS ARE EXTREMELY FRAGILE. HANDLE WITH CARE.
Read these instructions before beginning the installation.
1.Remove the Top Plate. Simply lift it up off of the stove body. It is not fastened.
2.Remove the Glass Frame. Disengage the two com- pression latches located at the top of the firebox and lift the glass frame up and off of the stove. See fig. 39.
3.If installed, remove the Logset. These parts are not fastened. Simply lift them out of the firebox. You do not have to remove the embers.
4.Install the Lower Rear Panel. Position it up against the back wall, resting on the burner skirt. Fig. 40.
5.Install a Side Panel. Tilt the panel, bottom edge first, into position against the side wall. The panel will stand on its own against the wall, fitting snugly between the rear panel and the front wall of the firebox. Fig. 41.
6.Install the Upper Rear Panel. Simply rest it on the other two panels. Fig. 42.
7.Install the other Side Panel.
8.Reinstall the Logset. Refer to the Owner’s Manual if necessary. BE CERTAIN THAT NO EMBER STONES ARE
BLOCKING THE PILOT ASSEMBLY OPENING.Refer to fig.36.
9.Replace the Glass Frame. Slide the frame down the slot in the front of the firebox. Be sure to push the frame into the slot in the bottom to ensure it is fully seated. The gasket at the top of the frame should be flush with the top of the firebox.
Pull the compression latches out to engage with the top lip of the glass frame.
10.Replace the Top Plate.
Upper Rear Panel
220745
Left Panel | Right Panel | |
220998 | ||
220999 | ||
|
Lower Rear Panel
220990
Figure 38. Brick Kit Contents
Figure 39. Disengage the compression latches to remove the glass frame.
Figure 40. Install Lower Rear Panel
Figure 41. Install Side Panel
Figure 42. Install Upper Rear Panel
22
