Jura Capresso 68193 warranty General Cleaning Instructions, Emptying the System Before Transport

If you push the Rotary Dial to enter one of the above programs, the display guides you through the necessary steps.

Please note: If the display shows MAINTENANCE and you do not select one of the above programs within five seconds, the S9 OT will return to COFFEE READY.

Example:

Run a manual hot water rinse cycle. COFFEE READY.

•Push the Rotary Dial until the display shows MAINTENANCE.

•Push the Dial again, CLEAN CAPPUCCINO.

•Turn the Dial until the display shows RINSE MACHINE.

•Place a cup under the Dual Coffee Spouts.

•Push the Rotary Dial. The S9 OT will push hot water through the Dual Coffee Spouts and then return to COFFEE READY.

15.2REMOVING STONES FROM THE BURR GRINDER If the burr grinder is blocked, proceed as follows:

• Turn off the machine by pushing the ON/OFF button (Fig. 2,B). Wait until the machine has shut down completely.

• Turn the main power switch off (Fig 1b).

• Open the bean container lid and remove all beans (scoop out beans or use a hand-held vacuum cleaner).

• Remove the screw in the bean container (Fig. 23) and push the grinder shield upwards (Fig. 24) Do not try to remove the shield completely.

• If any beans remain, remove them.

• Attach the burr grinder release tool (in Welcome Pack) to the upper burr (Fig. 25).

• If you cannot find this tool call 1-800-220-5701 and we will send the tool to you free of charge.

• Turn the tool counter-clockwise slowly until the stone becomes loose.

Attention: Do not try to turn the tool clockwise.

•Fold the shield down and replace the screw.

•Turn machine on and test the grinder without beans to see if the blockage has disappeared.

15.3 GENERAL CLEANING INSTRUCTIONS

Never use abrasive materials or chemicals to clean the machine.

•Clean the housing with a soft, damp cloth.

•Rinse water tank daily and fill with fresh cold water.

15.4 EMPTYING THE SYSTEM BEFORE TRANSPORT

This procedure is necessary to prevent water and frost damage in case you intend to transport the machine.

COFFEE READY

•Place a container under the Cappuccino system and the Hot Water Spout.

•Turn the machine off. The main power switch is still on.

•Press and hold the Rinse button until the display shows

SYSTEM EMPTYING

•A small amount of water is dispensed. When the process is completed the machine turns itself off.

The next time the machine is turned on, the display shows FILL SYSTEM/PRESS STEAM (chapter 6c).

15.5 CLEANING THE FROTHXPRESS

After frothing a few drops of milk remain inside the frothXpress. The S9 OT displays RINSE CAPPUCCINO. Follow the instruc- tions in chapter 10g.

31.