Jura Capresso 68193 8a. Turning the Machine OFF / Rinsing, Coffee Preparation 9a. PRE-WARM Cups

RINSING. The water will be caught in the drawer underneath. The rinse cycle stops by itself and the display reads: COFFEE READY. You are now ready to make coffee.

*Note: S9 OT can be programmed to automatically start the rinsing cycle after HEATING UP is displayed (chapter 14.7).

8a. TURNING THE MACHINE OFF / RINSING

Before turning off the S9 OT, place containers under the Dual Coffee Spouts and Auto Cappuccino System (Fig. 4).

When the S9 OT is turned off or turns itself off it will prompt for short cleaning cycles as follows:

Only the Dual Coffee spouts were used: The S9 OT displays MACHINE RINSING. For a few seconds hot water will be dispensed through the Dual Coffee Spouts and through the coffee spout of the Cappuccino section. The machine and the display turn off.

The Auto Cappuccino Spouts and the Dual Coffee Spouts were used: The S9 OT first displays CLEAN CAPPUCCINO and the Rinse button illuminates. If the Rinse button is not pushed within the next ten seconds, the display shows SPOUT RIGHT / PRESS RINSE. Press the Rinse button. The S9 OT will dispense some hot water through the coffee spout of the Cappuccino section. It will then push some hot water through the Dual Coffee Spouts and turn off.

Please note: When the S9 OT turns off you may hear a slight hissing noise.

9.COFFEE PREPARATION 9a. PRE-WARM CUPS

In the morning pre-warm your cups with hot water through the Hot Water Spout. Cold cups reduce the coffee temperature by 5ºF to 10ºF.

Place a cup under the Hot Water Spout, turn the Selector Dial (Fig. 3.3) until the display shows HOT WATER and push the Selector Dial. The display shows TEMP. XHIGH and water will flow into your cup. Push the Selector Dial again to stop and discard the water. COFFEE READY.

9b. BREWING COFFEE AND ESPRESSO

The machine has four pre-set coffee buttons, 1 ESPRESSO, 2 ESPRESSI, 1 COFFEE, 2 COFFEES (Fig. 2).

All buttons are pre-set for coffee strength, coffee volume and temperature (chapter 5).

•Place one or two cups underneath the Dual Coffee Spouts and push the desired button. The machine will grind, tamp and then brew the coffee. It uses a 2-step brewing process (pre-brew phase), pauses for a few seconds, and then starts

the brewing process. The display will show the name of the button you pushed, e.g. 1 ESPRESSO and the selected coffee strength indicated by a bean graphic, e.g. 4 beans = strong.

Please note: when pushing any of the two-cup buttons, the coffee strength is not displayed.

Important: After the brewing stops the machine will discard the used coffee grounds. Please do not try to pull out the drawer (Fig.1,18) during this operation. It can seriously damage the machine.There is no need to pull out the drawer until the display shows the message EMPTY TRAY or EMPTY GROUNDS.

16.