JVC AV-P960E manual Troubleshooting

Troubleshooting

When you encounter a problem, check the following points for a solution. If the problem persists, stop using this unit and consult your nearest JVC dealer.

Symptoms	Verify the following points	Refer to Page
No image appears.	● Is the power plug connected to an AC outlet?
	● Is the power switch turned on?	10
	● Is this unit connected correctly to the projector or display?	10
	● Is the brightness set to the optimum level?	6
	● Are you sure that the pictures have been stored to memory? First store the	17
	pictures to memory and then recall them.
	● Is [EXT IN] or [SD CARD] of [SOURCE SELECTION] being selected? Select	6
	[CAMERA].
	● Is a XGA compatible projector or display used?	10
Focusing is not possible.	● Is the close-up lens attached?	5
	● Is the object too close to the lens or is the top of the object at a height of more
	than 50 mm from the stage surface?
	● Did you shoot the surrounding objects with close-up lens attached? When shoot-	13
	ing surrounding objects, remove the close-up lens.
	● Did you enlarge the image size with the zoom after focusing was achieved?
	Perform focusing after enlarging the image with zoom.
	● With [FOCUS AUTO], focusing may be difficult depending on the object. Adjust	6
	the focus using [FOCUS , ] buttons.
	● If the unit is connected to the projector, make sure that the projector is focused
	correctly. Refer to the projector's instruction manual for focusing procedure.
The image is blurred.	● Is the close-up lens or camera lens dirty? Clean it with a commercially avail-
Dust is visible.	able cleaner.
The image is dark.	● Are the side illuminations lighted?	3
	● Is the brightness set appropriately?	6
Stripe pattern appears on	● Dots in the printed matter may interfere with the pixels in the camera image	11
the image of printed	device resulting in colour stripes. In this case, change the image size slightly
material.	with the [ZOOM] buttons.
The colour tone doesn’t	● Have you adjusted the tone with the [WHITE BALANCE]?	7
seem right.	● Make sure that the negative mode is not engaged.	7
Beats appear in the image.	● When this unit is used near equipment generating a strong electric wave, beats
	may occur in the image. Keep this unit away from such equipment.
The image flickers.	● In areas where the 50 Hz power frequency is used, flickering may occur on the
	screen when a fluorescent light or mercury-vapour lamp is used. Use this unit
	with the side illuminations lighted.
The image cannot be	● When the [FREEZE], [PICTURE MEMORY], [EXT IN] or [SD CARD] is se-	6,7
adjusted.	lected, the camera image cannot be adjusted. Return to [CAMERA] image to
	adjust.
	● When brightness is insufficient, this unit may not work properly even if you	7
	adjust the brightness. Press the [LIGHT] button to turn on the side illumina-
	tions.
This unit does not operate	● When two buttons are pressed simultaneously, or a button is repeatedly pressed
even when the button is	without pauses, the unit may not operate correctly. When operating the but-
pressed.	tons, do it one at a time with intervals between each press.
The remote control unit	● Are there batteries in the remote control unit?
does not work.	● Are the batteries exhausted?	11
	The batteries provided are for operation check only. Install commercially avail-
	able batteries for actual usage.
	● Is the remote control unit being operated outside the effective range?	23
The camera image has	● Black or white spots may occasionally appear due to the characteristics of the
white or black spots.	high-pixel CCD for graphics. If the image is enlarged with the digital zoom
	function, spots may be particularly noticeable.

English

E-25