Connections
16
To Connect:Plug one end of the AV Compu Link cable into the AV Compu Link input on your
VCR, DVD,or other Compu Link device. Plug the other end of the AV Compu Link cable into
the AVCompu Link input at the rear of the television.
Connecting to JVC AV Compu Link
JVC’s AVCompu Link feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape into your JVC-brand VCR or DVD into your JVC DVDplayer and
the device will automatically turn on and begin playback. At the same time, using the AV
Compu Link, the VCR or DVDplayer sends a signal to the television telling it to turn on and
switch to the proper video input.
The AVCompu Link cable may be included with the JVC AV Compu Link accessory you
wish to connect. If it is not, contact an authorized JVCService Center for
part # EWP 805-012.
• AVCompu Link can only be used with JVC-brand products.
NOTE:
In order for the VCR playback to begin automatically, the recording tabs must be remove from
the VHStape. If the tab is in place, automatic switching will occur when you push the VCR’s
PLAYbutton.
The AVCompu Link cable has a male 3.5 mm (mono) plug on each end.
If your JVC-brand VCRhas “A Code/B Code Remote Control Switching”(see your VCR’s
instruction book), using VCRA Code will switch the TV to input 1.
To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see
the HiFi’s connection instructions for detailed connection information.
AV COMPULINK EX is compatible with the following receivers:RX-664V, RX-665V,
RX-668VBK, RX-774V, RX-778VBK, RX-884V, RX-888VBK, RX-1024V, RX-1028VBK, and
later receiver models.
Illustration of AV-27F802
AV-27,32,36F7/802 A 9/4/01 9:44 AM Page 16