JVC CA-DXJ36 manual # Power cord, Cancelling the Demonstration, Preparing the Remote Control

#Power cord

Plug the AC power cord to a wall outlet.

DO NOT plug in before setting the voltage selector and all connection procedures are completed.

Cancelling the Demonstration

Main Unit

ONLY

2sec.

DEMO OFF

DEMO START

Connecting a USB Mass Storage Class Device

You can connect a USB mass storage class device such as a USB flash memory, hard disk drive, multimedia card reader, digital camera, etc. to this System.

USB cable (not supplied)

Main unit

•You cannot connect a personal computer to the (USB MEMORY) terminal of the System.

•When connecting with a USB cable, use the USB 2.0 cable whose length is less than 1m.

Preparing the Remote Control

Insert the batteries into the remote control by matching the polarrrity (+ and –) correctly.

R6(SUM-3)/AA(15F)

When using the remote control, point the top of the remote control toward the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.

•If the range of effectiveness of the remote control decreases, replace both batteries.

Caution:

Battery shall not be exposed to excessive heat such as sunshine, fire or the like.

To start the demonstration, select DEMO START.

Changing the Color System and

Scanning Mode	Remote	INFO
	ONLY

You can select the video output to match it to the color system of your TV (NTSC or PAL).

•If you connect a progressive TV through the COMPONENT jacks, you can enjoy a high quality picture by selecting progressive scanning mode.

•You can change the setting only while playback is stopped.

1 Enter the color system setting mode.

2sec.

SCAN MODE

2 Select the color system and scanning mode.

PAL PAL PROG

NTSC PROGNTSC

NTSC / PAL NTSC or PAL Interlaced scanning. For a conventional NTSC or PAL TV.

NTSC PROG/ NTSC or PAL Progressive

PAL PROG scanning. For a progressive NTSC

or PAL TV.

3 Store the setting.

6