![](/images/new-backgrounds/1043216/4321627x1.webp)
English
SHIFT B
L BALANCE R
S.A.BASS
or
CAUTION: The Volume cannot be adjusted while the Unit is on STANDBY. DO NOT turn on the Unit and/or start playing any source without setting the VOLUME control to 0; otherwise, the sudden blast of sound can damage your hearing, speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound comes out of the front speakers. Be sure to turn down the volume before connecting or putting on headphones.
Balance Adjustment ————————————————————
You can use the remote control to adjust the left and right balance of the speakers.
1. Press and hold SHIFT B.
2. Press BALANCE L (10) or R (+10).
The display changes to show the balance adjustment.
Pressing L (10) moves the pointer to the left, pressing R (+10) moves the pointer to the right.
Display when set for no | Display at the | Display when set for no |
sound from the right speaker. | center position. | sound from the left speaker. |
The balance is normally set to the center position.
Note: If no adjustments are made for 2 seconds, the display reverts to the previous display.
3. Release SHIFT B.
Reinforcing the Bass Sound
S.A. (Signal Adaptive) BASS adjusts low tones at low volume to enhance their effect. When the volume level is low, this enhances low tones that are normally difficult to hear and adjusts low tones to a fixed level to reduce low tone distortion.
Press S.A. BASS.
Each time you press the button, the bass setting changes as follows:
=
The S.A. BASS indicator lights up, and
To cancel the effect, press S.A. BASS until “OFF” appears on the display. The button light goes out.
To recall the previous S.A. BASS mode, press S.A. BASS once.
When listening to recording with low volume low tones, the difference between
Muting Sounds
FADE MUTING
Press FADE MUTING on the remote control to turn down the volume.
To restore the previous volume level, press the button again.
You can also increase the volume by using VOLUME on the Unit or VOLUME + on the remote control.
10