JVC CA-V608T, CA-V688T, CA-V908T, MX-V688T Presetting Stations, Switching between Frequency Bands

Switching between Frequency Bands———————————

or	FM/AM	Press FM/AM.
		Each time you press the button, the band alternates between FM and AM.

COMPU PLAY

When FM/AM is pressed while the power is on standby, the power is automatically turned on.

English

NEXT

or

PREV

NEXT

or

			PREV
PRO LOGIC 3CH LOGIC			TEST TONE
–	CENTER	+	ONSCREEN
	LEVEL		CENTER MODE
–	REAR	+	V.INTRO
	LEVEL		DELAY TIME
L	BALANCE R		HIGHLIGHT

Three Ways to Select a Station ——————————————

Press TUNING DOWN or TUNING UP on the MULTI CONTROL repeatedly to move from frequency to frequency until you find the one you want. (Manual Tuning).

OR

Press and hold TUNING DOWN or TUNING UP on the MULTI CONTROL for a few seconds, the frequency starts changing on the display. When a station is tuned in, the frequency stops changing. (Auto Tuning).

OR

Possible only after presetting stations.

Press once and release P. DOWN or P. UP on the MULTI CONTROL to go to the next preset station.

You can also use the remote control to tune in preset channels:

1.Press FM/AM so that you can receive the last station tuned in.

2.Select the station by entering the preset number in the number keys of the remote control.

• Example: for channel 5, press 5. For channel 15, press +10 then 5.

For channel 20, press +10, then 10. For channel 30, press +10 twice then 10.

•After you have selected the preset number and the number appears, the broadcast frequency of the selected channel appears on the display.

	Presetting Stations
	You can preset up to 30 FM stations and up to 15 AM stations for the preset numbers.
	Note: In some cases, test frequencies have been already memorized for the tuner since the factory
	examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations
1	you want into memory by following the presetting method.

1. Select a band by pressing FM/AM on the Unit.

2		2.	Press TUNING DOWN or TUNING UP on the MULTI CONTROL to tune
			into a station.
		3.	Press SET.
		NEXT	“SET” flashes for 5 seconds.
		or
			While it is still flashing, carry out the following procedure.
		PREV
		4.	Press P. DOWN or P. UP on the MULTI
			CONTROL on the Unit to set the preset number.
3 ,	5	5.	Press SET again.
			“STORED” appears for 2 seconds. The preset station is
			stored in the memory.
		6.	Repeat steps 1 to 5 for each station you want to store in memory
			using different preset numbers.
4		CAUTION: If the Unit is unplugged or if a power failure occurs, the preset
		stations will be erased in a few days. If this happens, preset the station

again.

19