Installation

CAUTION

Do not rest your arm on the monitor or lean against the monitor.

Do not touch the LCD panel when installing the monitor.

Make sure to install the monitor securely to prevent the monitor from falling over, which causes damage to the monitor or injury.

You can place the monitor in the following two ways when using the monitor on the supplied stand.

4

To detach the stand

CAUTION

Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.

Attachment screws

You can tilt the monitor from about 6° upward to about 6° downward.

When the monitor is not tilted (0°), the guidelines align as illustrated below.

About 6°

About 6°

Guidelines

CAUTION

Be careful not to pinch your fingers in the gap between the monitor and the stand.

When the stand plate is attached to the lower position of the stand body (“To adjust the stand height” on page 5), you cannot tilt the monitor downward.

When the stand plate is attached to the higher position of the stand body (“To adjust the stand height” on page 5), you can lift the stand up by about 148° and place the monitor as illustrated below.

Remove the screws on the left and right sides of the stand (see the illustration below), then lift the stand up by about 148°.

Make sure of attaching the removed screws after lifting up the stand.

To place the monitor as illustrated on the left again, remove the screws on the left and right sides of the stand, return the monitor angle to 0°, then attach the removed screws.

About 148°

Screw (silver)

CAUTION

When lifting up the stand, lay the monitor on a cloth

 

with the LCD panel facing down to prevent the LCD

 

panel being damaged.

Be careful not to pinch your fingers in the moving

 

parts.

Screw holes for stand attachment

Monitor

When installing the stand to the monitor, insert the guides of the stand into the guide holes on the monitor to place the stand on the correct position. Then fix the stand firmly with the attachment screws.

Guide holes

Guides

Make sure to lift the stand up until it stops (about

 

148°); otherwise the monitor may fall over.

Place the monitor on a mat to avoid scratching the

 

table surface.

Do not lift up the stand when the stand plate is

 

attached to the lower position of the stand body (“To

 

adjust the stand height” on page 5).

When the battery is attached, the stand may not be

 

lifted up depending on the type of the battery.

Monitor

Screw holes for stand attachment

 

(on the monitor)

Screw holes for stand attachment (on the stand)

Stand plate

Stand body

Page 5
Image 5
JVC DT-V17L2D manual Installation, To detach the stand