JVC DT-V24G1 Example of the vector scope, Example of the wave form monitor, Scope SETTING*1

Operation guide

Shows the buttons for each operation.

•The menu automatically disappears in about 30 seconds after the previous operation.

•Some items may not appear on the menu depending on the input or the input signal.

•The items controlled by the MAKE system do not appear on the menu.

SCOPE SETTING*1

Settings for the wave form monitor and vector scope

Item	To do	Setting value
GAIN	Adjust the gain level for the incoming wave form data.	–10 – +10
SIZE*2	Select the size of the wave form monitor and vector scope window.	NORMAL, LARGE
POSITION*2	Select the position of the wave form monitor and vector scope	1 (lower right), 2
	window.	(lower left), 3 (upper
		left), 4 (upper right)
TRANSPARENT	Activates/deactivates the function to make the window translucent.	ON (translucent),
		OFF (normal)
AUTO OFF	Activates/deactivates the function to make the wave form monitor and	ON, OFF
	vector scope window go off automatically 15 minutes after displaying it.
WAVE DISPLAY	Select the wave form for the wave form monitor.	Y/Pb/Pr (HD signals)
		Y/Cb/Cr (SD signals)
		R/G/B (RGB signals)
WAVE FILTER	Activates/deactivates the low-pass filter for the incoming wave form	FLAT (no filter),
	data.	LOWPASS
WAVE OVER	Adjust the over level for the incoming luminance (Y) and RGB	☞ “NOTE”
LEVEL	signals.
MARKING	Activates/deactivates the function to change the color of a wave form	OFF, ON
	when the signal exceeds the limit specified on “LEVEL” (☞ below).

NOTE

Example of the vector scope

Ex.: When the color bar is displayed

Example of the wave form monitor

Ex.: When the luminance signal is Y, “MARKING” is set to “ON” and “LEVEL” is set to “080”

Red White

LEVEL Adjust the lower limit for the over level. 070 – 109

*1 Wave form monitor does not work for DVI signals (PC input). Vector scope does not work for RGB signals.

*2 When you set “SIZE” to “LARGE,” the window is displayed in the center of the screen regardress of the “POSITION” setting.

SYNC FUNCTION

Settings for the synchronization with signals

Y

	Video signal
Start	End

•The wave which goes over the value set on “LEVEL” is indicated in red.

•The display differs depending on the input signal or the setting of “WAVE DISPLAY.”

Item	To do		Setting value
NO SYNC ACTION	Select the screen status when no signal is coming in.		OFF, P.SAVE (power save
			mode), GRAY B. (gray screen)
DELAY TIME	Select the period until the screen status changes as selected		30sec., 5min., 15min.
	in “NO SYNC ACTION” after signals stop coming in.
SYNC INPUT	Select the sync signal for the VIDEO1, VIDEO2 and		INT. (Internal sync),
SEL.*3	COMPO./RGB input.		EXT. (External sync)
LOW LATENCY	Activates/deactivates the function to shorten the time		ON, OFF
	taken to display the picture (low latency function).
	•	If the picture is not displayed steadily while “ON” is
		selected, select “OFF.”
	•	While “ON” is selected, the displayed picture may
		become unstable when an operation using buttons on
		the front panel or the menu is performed, or when the
		signal format changes.

•When setting “NO SYNC ACTION” to “GRAY B.,” the screen color changes to gray and the power consumption of the back light is saved by half. Selecting “P.SAVE” (power save mode) saves more power consumption by

turning off the back light. *3 Memorized for each input.

ENGLISH15