Manuals / Brands / Computer Equipment / Computer Monitor / JVC / Computer Equipment / Computer Monitor

JVC DT-V20L1, DT-V20L1D, DT-V24L1, DT-V24L1D 7 Installing the monitor in the rack

1 20

Download 20 pages, 1.26 Mb

5

7 Installing the monitor in the rack

Use a JVC’s RACK MOUNT ADAPTER (RK-C20L1; not supplied).

CAUTION

• Detach the stand first.

• Ask your dealer to install.

To adjust the stand height

You can select the stand height—higher position or lower position.

To change the stand height, change the position of the stand plate as illustrated below after detaching the stand

from the monitor.

• For detaching the stand, see “To detach the stand” on page 4.

<Higher position> <Lower position>

Screw holes for higher position Screw holes for lower position

Stand plate

Stand plate

Stand body Stand body

To prevent an accidental fall

Fix the stand to a table or floor with M5 screws (not supplied).

• Choose the screws of proper length corresponding to the thickness of the table or floor.

Screw holes

(See page 18 for the specifications of the screw holes.)

Screw holes

(See page 18 for the specifications of the screw holes.)

The illustration of the monitor is of DT-V24L1D.

<Top side view>

(DT-V20L1D and DT-V20L1 only)

DT-V2420L1D_UA.indd 5DT-V2420L1D_UA.indd 5 06.11.7 9:16:21 AM06.11.7 9:16:21 AM

Contents

Main INSTRUCTIONS DT-V24L1D DT-V24L1 DT-V20L1D DT-V20L1 MULTI FORMA T LCD MONITOR Safety Precautions IMPORTANT SAFEGUARDS Maintenance Screen Information for Users on Disposal of Old Equipment Dear Customer, Cabinet Installation 7 Using the monitor on the stand To detach the stand 7 Installing the monitor in the rack To adjust the stand height To prevent an accidental fall Daily Operations / Connections 7 Front panel w e r 1 2 audio channel selection. then press button. 3 1 screen for audio channel selection. 2 (L) or right (R). 3 Daily Operations / Connections 1 2 3 Attaching the Power Cord Holder 7 Available signals The following signals are available for this monitor. Video signals Acceptable Computer signals (preset) DVI-D (HDCP) terminals Specification of DVI-D (HDCP) terminal Connect it to DVI-D output terminal on a personal computer. Menu Configuration PICTURE IMPROVEMENT BACK LIGHT DVI INPUT SEL. COMPO./RGB SEL. Setting of sub menu POSI. Setting of E.AUDIO GROUP Example of the level meter display Level indication and audio channels Ex.: When LEVEL METER ch is set to 12:78 and BAR TYPE is set to 3COLORS. Operation guide Shows the buttons for each operation. Menu Configuration FUNCTION SETTING Setting for the tally lamp PICTURE SUB ADJ. SIZE/POSI. ADJ. 1 2 3 4 5 7 Using the MAKE/TRIGGER system See also page 15. To assign the functions to the pin terminals For the operation procedure, see page 7. External Control 7 About the external control RS-485 RS485*1 RS-232C RS232C*1 <Serial communication> 7 Using the serial communication <Specifications of RS-485 terminal> 4 1 3 5 6 2 Troubleshooting 7 Self-check program 1 2 3 4 Specifications 7 General 7 Input/output terminals Specifications (cont.) DT-V20L1D/DT-V20L1 <Stand bottom> <Front view> <Side view> <Rear view> 7 Dimensions Unit: mm (inch)