JVC G1000S Select the video input to be projected, Basic Operations Cont, English, Attentions

Basic Operations (Cont.)

■ Projector’s buttons 2. Select the video input to be projected

STAND BY

■Press the VIDEO button or the COMPUTER button to switch the input.

• Each time you press either button, the selected input changes as follows.

LAMP	■ When you press VIDEO:
TEMP	Y/C	VIDEO	Y,PB/B-Y,PR/R-Y

EMERGENCY

■When you press COMPUTER:

VIDEO	VIDEO button	COMPUTER1	COMPUTER2
COMPUTER	COMPUTER button
SETTING		Remote control unit	Projector
+3		COMPUTER VIDEO
			VIDEO
QUICK
ALIGN.
-2			COMPUTER

■Remote control unit

COMPUTER button

OPERATE COMPUTER VIDEO VIDEO button

VOL.	FOCUS
PAGE	MENU/ENTER
BACK
PRESET
QUICK	AV
ALIGN.	MUTING

Screen display

V I D E ON T S C

*When the input is switched, the line display (ex. VIDEO) and the source display (ex. NTSC) are shown on the upper part of the screen (they disappear in about five seconds). However, they will not be shown if LINE DISPLAY in “Setting and Adjusting Other Functions (OPTIONS)” on page 43 is set to OFF.

(For setting the source, see page 46.)

Note

• To select the proper audio input for video input

The video input terminal (AV IN input terminal) can be switched with the VIDEO button. However, since this projector has only a single audio input terminal, reconnect audio input in accordance with the AV device to be used.

ENGLISH

ATTENTIONS

•DO NOT give any shock to this projector while operating it; otherwise, the light-source lamp goes off (the EMERGENCY indicator lights up).

If the shock turns off the light-source lamp —

Turn off the power by pressing the MAIN POWER switch, then turn it on again. Now you can operate the projector as usual.

27

G1000S 26-33.EN 27 98.9.21, 9:53 AM