Controls and Features
Front Side / Top Surface / Right Side
1
- +
9
8
7
2
|
| 3 |
6 5 4 | ||
|
|
|
1 Control panel | 4 Adjustable foot (for adjusting upper/lower angles) | |
For details, refer to “Control Panel” (page 9). | It is adjusted to be level when shipped from the factory. | |
|
| Turning to extend the foot allows adjustment up to +7°. |
2 Exhaust vents | * This adjustable foot can be removed. Turn the foot and | |
Vents for cooling fans through which warm air comes out. | extend it until removed. (Screw size available here is M8.) | |
CAUTION
•Do not block the exhaust vents, or heat builds up inside, possibly causing a fire. Also, do not touch the vents, or this could cause a
3Carrying handle
Raise this handle when carrying the projector.
How to use the carrying handle
Carrying handle
CAUTIONS
•When carrying the projector, do not give a shock to it. Be careful to keep its balance.
•Do not carry it while the light source lamp is on or the cooling fan is operating. This could cause personal injury.
|
|
| +7˚ |
MAIN | AC IN | ~ |
|
POWER |
|
| |
ON |
|
|
|
OFF |
|
|
|
|
| Higher | Lower |
5Built-in speaker (left)
6
7Lens
Before projection, remove the lens cap.
8Lens cap
The cap has a string attached and the string is fixed to the projector when shipped from the factory. It is recommended that the cap should be fitted on to prevent the lens becoming dirty when the projector is not used.
9Remote sensor
When operating with the remote control, aim it toward this sensor. You can also operate the remote control by pointing it to a screen and allowing the remote sensor to receive the reflected light.
6
G1000S | 6 | 98.9.21, 9:46 AM |
