JVC GR-AXM307EG instruction manual Counter R/M Power, START/STOP REW Pause Insert Play

NOTES:

Press STOP.

7

RESET COUNTER

3 Press and hold COUNTER R/M for more than

2 seconds to reset the tape counter, then press for less than 1 second and make sure “M” appears in the LCD monitor or the viewfinder.

FIND EDIT-IN POINT

4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE at exactly at the Edit-in point where the new scene should start.

ENGAGE INSERT EDITING MODE

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged, and the scene the camcorder is aimed at appears on the screen.

BEGIN INSERT EDITING

6 Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

END INSERT EDITING

FIND EDIT-OUT POINT

Set the Power switch to “PLAY”.

1

2 Play back the tape, locate the Edit-Out point and press PAUSE on the camcorder or the remote control.

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the RM-V704U or RM-V700U remote control unit to perform this procedure.

SELECT MODE

38EN USINGREMOTECONTROLUNIT (cont.)

COUNTER R/M

POWER

M-1:23:45	Tape Counter
	Insert Editing Indicator

LCD monitor or viewfinder

START/STOP

REW

PAUSE

INSERT

PLAY

RM-V704U or

RM-V700U (provided)

●When Insert Editing is performed with the LCD monitor fully opened, the original audio will be heard from the speaker.

●After step 5, Retake (☞ pg. 14) can be performed.

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only video signal is recorded in the Insert Editing mode.