JVC GR-AXM307EG instruction manual Remote sensor, Rec Time Indicator Interval Timer Indicator

Transmitted beam effective area

15° 5m(16.4ft)

30
°	30°
15°

Remote sensor

	EN 37
FEATURE:	Self-Timer, Animation and Time-Lapse
PURPOSE:	The remote control lets you set/release
	Interval Timer and Rec Time functions
	as well as the Menu screen.
OPERATION:	Self-Timer
	1) Set
	Instead of performing steps 1 through
	3 on pg. 26 (“Self-Timer”), press INT.
	TIME on the remote control. Each
	time INT. TIME is pressed, the
	Interval Timer indicator appears,
	changing in the following order: 15S,
	30S, 1MIN, 5MIN and No indication

When using the remote control, be sure to point it at the remote sensor. The above illustration shows the approximate transmitted beam effective area for indoor use.

The transmitted beam may not be effective or may cause incorrect operation outdoors or when the remote sensor is directly exposed to sunlight or powerful lighting.

Rec Time Indicator

Interval Timer Indicator

		Index Code
1MIN	INDEX
1/2S		Marking

LCD monitor or viewfinder

START/STOP

VISS

INT. TIME

REC TIME

RM-V704U or

RM-V700U (provided)

	(off).
	2) Release
	Instead of setting “INTERVAL TIMER”
	to “OFF” in the Menu, press INT.
	TIME on the remote control until the
	Interval Timer indicator disappears.
	Animation
	1) Set
	Instead of performing steps 1 and 2
	on pg. 27 (“Animation”), press REC
	TIME on the remote control. Each
	time REC TIME is pressed, the Rec
	Time indicator appears, changing in
	the following order: 1/4S, 1/2S, 1S
	and No indication (off).
	2) Release
	Instead of using the Menu in step 5
	on pg. 27, press REC TIME on the
	remote control until the Rec Time
	indicator disappears.
	Time-Lapse
	1) Set
	Instead of performing steps 1 through
	3 on pg. 27 (“Time-Lapse”), press
	INT. TIME and REC TIME on the
	remote control. Each time INT. TIME
	is pressed, the Interval Timer
	indicator appears, changing in the
	following order: 15S, 30S, 1MIN,
	5MIN and No indication (off). Each
	time REC TIME is pressed, the Rec
	Time indicator appears, changing in
	the following order: 1/4S, 1/2S, 1S
	and No indication (off).
	2) Release
	Instead of using the Menu in step 5
	on pg. 27, press INT. TIME and REC
	TIME on the remote control until the
	indicators disappear.
NOTE:	Also refer to pgs. 26 and 27.
FEATURE:	Index Code Marking
PURPOSE:	To give you automatic access to any
	selected point on a recording.
OPERATION:	1) Press VISS once to place the index
	code. “INDEX” blinks in the LCD
	monitor or the viewfinder during
	marking.
NOTE:	If VISS is pressed during Record–
	Standby mode, the mark is placed
	where START/STOP is pressed.