Still images can be dubbed from a tape to a memory card.
Play/Pause Button
(PLAY (4/9))
SNAPSHOT Button
VIDEO/MEMORY Switch
1Load a cassette. ( pg. 15)
2Load a memory card. ( pg. 16)
3Set the VIDEO/MEMORY Switch to “VIDEO”.
4Set the Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
5Set “
COPY” to “ON”. ( pg. 31, 40)
6Press PLAY (4/9) to start playback.
7At the point you want to dub, press PLAY (4/9) again to engage Still Playback.
8To dub the image, press SNAPSHOT.
●The ” 
” indication appears during dubbing.
●The selected image is stored in the memory card.
NOTES:
●If SNAPSHOT is pressed in step 8 when a memory card is not loaded, the message “COPYING FAILED” is displayed.
●If an image recorded on the tape using “WIDE MODE” ( pg. 37) is dubbed to a memory card, the WIDE mode identifying signal is not dubbed with it.
●To use Playback Special effects with a video image you wish to dub, perform up to step 8 using the remote control (provided). ( pg. 58)
●Images are dubbed in 640 x 480 pixels.