JVC LYT0002-0F2A manual REC pg, Close the cassettes cover, Play pg, Don’t work, System Menu pg

TROUBLESHOOTING EN 67

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer or Technical Service Center.

	SYMPTOM	POSSIBLE CAUSES	CORRECTIVE ACTION
1.	No power is supplied.	1. •The power is not connected	1. •Connect the AC Adapter
		properly.	securely (☞ pg. 10).
		•The battery is dead.	•Replace the dead battery
		•The LCD monitor is not	with a fully charged one
		open fully when recording.	(☞ pg. 9).
			•Open the LCD monitor
			fully. The LCD monitor
			turns on/off when it is
			opened/closed at an angle
			of 45 degrees while the
			Power Dial is set to “REC”.
2.	Recording cannot be	2. •The tape’s record safety tab	2. •Set the tape’s record safety
	performed.	is set to “SAVE”.	tab to “REC” (☞ pg. 13).
		•The Power Dial is set to	•Set the Power Dial to
		“PLAY”.	“REC” (☞ pg. 19).
		•The cassette's cover is open.	•Close the cassette's cover.
3. There is no playback		3. •The camcorder is not getting	3. •Turn the camcorder’s power
	picture.	power, or some other	off and on again (☞ pg. 19).
		malfunction exists.
4. Some functions are not		4. •The shooting mode selector	4. •Set the shooting mode
	available.	is set to “AUTO”.	selector to "MANUAL"
		•The Power Dial is set to “5S”.	(☞ pg. 18).
			•Set the Power Dial to any
			position except “5S”
			(☞ pg. 28).
5. The focus does not adjust		5. •Focus is set to “MANUAL”.	5. •Set Focus to “AUTO”
	automatically.	•The recording was done in a	(☞ pg. 46).
		dark place, or the contrast	•Clean the lens and check
		was low.	the focus again (☞ pg. 72).
		•The lens is dirty or covered
		with condensation.
6. The cassette won’t load		6. •The cassette is in the wrong	6. •Set it in the right position
	properly.	position.	(☞ pg. 13).
		•The battery’s charge is low.	•Install a fully charged
			battery (☞ pg. 8).
7.	Play, Rewind and	7. •The Power Dial is not set to	7. •Set the Power Dial to
	Fast-Forward functions	“PLAY”.	“PLAY” (☞ pg. 49).
	don’t work.	•The cassette’s cover is open.	•Close the cassette's cover
			(☞ pg. 13).
8. The tape is moving, but		8. •The LCD monitor is turned	8. •Press and hold the IND/
	there’s no picture.	off.	DISPLAY button for over 2
		•Your TV has AV input	seconds (☞ pg. 23).
		terminals, but is not set to	•Set the TV to the mode or
		its VIDEO mode.	channel appropriate for
			video playback (☞ pg. 53).

9.In the 5-Second mode, recording ends before 5 seconds have elapsed.

9. •The 5-Second mode in the	9. •Select “5S” or “5SD” in the
System Menu is set to	System Menu (☞ pg. 33).

“ANIMATION”.

CONTINUED ON NEXT PAGE