JVC GR-DVM96 48 EN, System Menu, Beep, melody and shutter sound, Tally lamp setting

48 EN					RECORDING MENUS (cont.)
		System Menu
			SYSTEM		(	: Factory-preset)
Beep, melody and shutter sound
	BEEP			OFF	Even though not heard while shooting, shutter sound is recorded on the
					tape.
				BEEP	The beep sounds when the power is turned on or off, and at the
					beginning and end of recording. It also activates the shutter sound effect.
					( pg. 27, 53)
				MELODY	Instead of a beep, a melody sounds when any operation is performed. It
					also activates the shutter sound effect. ( pg. 27, 53)

Tally lamp setting

TALLY

OFF

ON

The tally lamp remains off at all times.

The tally lamp comes on to signal the start of recording.

Automatic demonstration mode

Demonstrates certain functions such as Program AE with special effects, etc., and can be used to confirm how these functions operate. (
pg. 8)

DEMO MODE	OFF	Automatic demonstration will not take place.
	ON	Demonstrates certain functions such as Program AE with special effects,
		etc., and can be used to confirm how these functions operate.
		Demonstration starts in the following cases:
		•When the Menu Screen is closed after “DEMO MODE” is turned “ON”.
		•With “DEMO MODE” set to “ON”, if there is no operation for about
		3 minutes after the Power Switch is set to “A” or “M”.
		Performing any operation during the demonstration stops the
		demonstration temporarily. If no operation is performed for more than 3
		minutes after that, the demonstration will resume.
		NOTES:
		● If a cassette is in the camcorder, the demonstration cannot be turned on.
		● “DEMO MODE” remains “ON” even if the camcorder power is turned off.
		● If “DEMO MODE” remains “ON”, some functions will not be available.
		After viewing demo, set to “OFF”.