JVC GR-DVM96 instruction manual Select Scenes, If the search time for an in-point exceeds

EN 75

Select Scenes

Remote sensor

FADE/WIPE

PLAY

●Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

●If you select a Wipe/Fader effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

●When you use Wipe/Fader effects, that time is included in the total time.

11If using Playback Special Effects, press EFFECT. (
pg. 69)

12Repeat steps 8 through 11 to register additional scenes.

●To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.

●If you are not using Wipe/Fader or Program AE with special effects, repeat steps 8 and 9 only.

NOTES:

● When choosing a scene, set Edit-In and Edit-Out

points so that there is a relatively large difference

between them.

● If the search time for an in-point exceeds

EFFECT

EDIT IN/OUTR.A.EDIT ON/OFF

CANCEL

6Point the remote control at the camcorder’s remote sensor. Press PLAY (U) and then press R.A.EDIT ON/OFF on the remote control. The Random Assemble Editing Menu appears.

Selected parameter
		I N	OUT MODE	Random Assemble
				Editing Menu
	1 – – – – : – –		~

2~

3~

4~

5~

6~

7~

8~

T I ME CODE	– – : – –
TOTAL	0 0 : 00

7If using a Wipe/Fader at the beginning of the scene, press FADE/WIPE on the remote control.

●Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

8At the beginning of the scene, press EDIT IN/ OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu.

9At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears in the Random Assemble Editing Menu.

10If using a Wipe/Fader at the end of the scene, press FADE/WIPE.

5 minutes, the recording deck’s Record-Standby

mode will be cancelled and editing will not take

place.

● If there are blank portions before or after the Edit-

In and Edit-Out points, a blue screen may be

included in the edited version.

● Since time codes register time only as accurately

as seconds, the time code total time may not

match the total program time exactly.

● Turning off the camcorder’s power erases all

registered Edit-In and Edit-Out points.

● If you select Sepia or Monotone mode from

Program AE with special effects, you cannot use

the Black & White Fader. In this case the Black &

White indicator begins blinking. Once the next

Edit-In point is registered, the effect is turned off.

To combine these effects, use Sepia or Monotone

during recording, then use the Black & White

Fader during Random Assemble Editing.

● It is not possible to use Wipe/Fader effects and

Program AE with special effects during Random

Assemble Editing using a DV cable.

CONTINUED ON NEXT PAGE