JVC GR-DVM96 instruction manual 86 EN, Angle of the LCD monitor, Camcorder When the LCD monitor’s

86 EN				TROUBLESHOOTING (cont.)
	31.	When the image is printed	31.	•This is not a malfunction.	31.	•By recording with “DIS”
		from the printer, a black bar				activated ( pg. 46) this can
		appears at the bottom of the				be avoided.
		screen.
	32.	When the camcorder is	32.	•The DV cable was plugged/	32.	•Turn the camcorder’s power
		connected via the DV		unplugged with power		off and on again, then
		connector, the camcorder does		turned on.		operate it.
		not operate.
	33.	The rear of the LCD monitor is	33.	•The light used to illuminate	33.	•Close the LCD monitor to
		hot.		the LCD monitor causes it to		turn it off or set the Power
				become hot.		Switch to “OFF”, and let the
						unit cool down.
	34.	Images on the LCD monitor	34.	•In places subject to low	34.	•Adjust the brightness and
		appear dark or whitish.		temperature, images become		angle of the LCD monitor.
				dark due to the		( pg. 13)
				characteristics of the LCD
				monitor. When this happens,
				the displayed colours differ
				from those that are actually
				recorded. This is not a defect
				of the camcorder.
				•When the LCD monitor’s
				fluorescent light reaches the
				end of its service life, images
				on the LCD monitor become
				dark. Consult your nearest
				JVC dealer.
	35.	Coloured bright spots appear	35.	•The LCD monitor and the	35.
		all over the LCD monitor or the		viewfinder are made with
		viewfinder.		high-precision technology.
				However, black spots or
				bright spots of light (red,
				green or blue) may appear		—
				constantly on the LCD
				monitor or the viewfinder.
				These spots are not recorded
				on the tape. This is not due to
				any defect of the unit.
				(Effective dots: more than
				99.99 %)
	36.	The indicators and the image	36.	•This may occur when the	36.
		colour on the LCD monitor are		surface or the edge of the		—
		not clear.		LCD monitor is pressed.
	37.	The cassette will not load	37.	•The cassette is in the wrong	37.	•Set it in the right position.
		properly.		position.		( pg. 16)
				•The battery’s charge is low.		•Install a fully charged battery.
						( pg. 10, 11)
	38.	The memory card will not load	38.	•The memory card is in the	38.	•Set it in the right position.
		properly.		wrong position.		( pg. 17)
	39.	The memory card cannot be	39.	—	39.	•Push in the memory card a
		removed from the camcorder.				few more times. ( pg. 17)