JVC GR-DVM96 instruction manual 70 EN, Audio Dubbing

9D

MIC

GR-DVM96 only

70 EN USING THE REMOTE CONTROL UNIT (cont.)

Audio Dubbing

The audio track can be customised only when recorded in the 12-bit and SP modes. (
pg. 44)

Stereo microphone

Speaker

Remote sensor

	Open the
Headphone connector	connector cover.
(GR-DVM96 only)

A.DUB

PLAY

PAUSE

STOP

1Play back the tape to locate the point where editing will start, then press PAUSE (9).

2 While holding A. DUB (D) on the remote control, press PAUSE (9). The “9D” indicator appears.

3Press PLAY (U), then

begin “narrating”. Speak into the microphone.

●To pause dubbing, press PAUSE (9).

4To end Audio Dubbing, press PAUSE (9), then STOP (8).

To hear the dubbed sound during playback… Set “12BIT MODE” to “SOUND 2” or “MIX”. (
pg. 38, 51)

NOTES:

●Sound is not heard from the speaker during Audio Dubbing. To hear sound, connect optional headphones to the headphone connector. (GR-DVM96 only)

●When editing onto a tape that was recorded at

12-bit, the old and new soundtracks are recorded separately.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-bit to 16-bit in mid- recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit audio or a blank portion, Audio Dubbing stops.

●To perform Audio Dubbing while watching on the television, make connections. (
pg. 24, 25)