JVC GR-DVX10 specifications Menu Screen Explanations, EN27

Menu Screen Explanations					EN27
	FADER/WIPE			Refer to “Fade/Wipe Effects” ( pg. 34, 35).
	P.AE/EFFECT			Refer to “Programme AE With Special Effects” ( pg. 36).
	W.BALANCE			Refer to “White Balance Adjustment” and “Manual White Balance Operation”
				( pg. 39).
	REC MODE			Allows you to set the recording mode (SP or LP) depending on your
				preference ( pg. 11).
	SOUND		12 BIT	Enables video recording of stereo sound on four separate channels, and is
	MODE			recommended for use when performing audio dubbing. (Equivalent to the 32
				kHz mode of previous models)
			16 BIT	Enables video recording of stereo sound on two separate channels. (Equivalent
				to the 48 kHz mode of previous models)
	ZOOM		10X	When set to “10X” while using digital zoom, the zoom magnification will
				reset to 10X since digital zoom will be disengaged.
			40X	Allows you to use the Digital Zoom. By digitally processing and magnifying
				images, zooming is possible from 10X (the optical zoom limit), to a maximum
				of 40X digital magnification.
			200X	Allows you to use the Digital Zoom. By digitally processing and magnifying
				images, zooming is possible from 10X (the optical zoom limit), to a maximum
MENU				of 200X digital magnification.
	SNAP		FULL	Refer to “Snapshot (For Video Recording)” ( pg. 18).
	MODE
CAMERA			PIN-UP
	GAIN UP		AGC	The overall appearance may be grainy, but the image is bright.
			OFF	Allows you to shoot dark scenes with no picture brightness adjustment.
			AUTO	The shutter speed is automatically adjusted (1/25 — 1/200 sec.). Shooting a
				subject in low or poor lighting at 1/25 sec. shutter speed provides a brighter
				image than in the AGC mode, but the subject’s movements are not smooth or
				natural. The overall appearance may be grainy. When shooting a subject in
				low lighting in this mode, “	” is displayed.
	BEEP/		ON: MEL.	The tally lamp comes on to signal the start of recording. Instead of a beep, a
	TALLY			melody sounds when any operation is performed. It also activates the shutter
				sound effect ( pg. 18, 19).
			ON:BEEP	The tally lamp comes on to signal the start of recording.
				The beep sounds when the power is turned on or off, and at the beginning and end
				of recording. Also to activate the shutter sound effect ( pg. 18, 19).
			OFF	The tally lamp remains off at all times.
				Even though not heard while shooting, shutter sound is recorded on the tape.
	ID		This number is necessary when connecting the camcorder to a device such as a computer
	NUMBER		using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06.
		: Factory-preset

NOTE:

The “ CAMERA MENU” settings are effective when the Operation Switch is set to both “ ” and “ ”.

CONTINUED ON NEXT PAGE