EN47
Battery Packs
The battery packs are nickel-cadmium
or nickel metal-hydride batteries.
Before using the supplied battery pack
or an optional battery pack, be sure to
read the following cautions:
1.To avoid hazard . . .
...do not burn.
...do not short-circuit the terminals.
...do not modify or disassemble.
...use only specified chargers.
2.To prevent damage and prolong service life . . .
...do not subject to unnecessary shock.
...avoid repeated charging without fully discharg-
ing.
...charge in an environment where temperatures
are within the tolerances shown in the chart
below. This is a chemical reaction type
battery—cooler temperatures impede chemical
reaction, while warmer temperatures can
prevent complete charging.
...store in a cool, dry place. Extended exposure to
high temperatures will increase natural
discharge and shorten service life.
...avoid prolonged uncharged storage.
...remove from charger or powered unit when
not in use, as some machines use current even
when switched off.
NOTES:
●

It is normal for the battery pack to be warm after

charging, or after use.

Temperature Range Specifications

Charging.............. 10°C to 35°C (50°F to 95°F)

Operation............ 0°C to 40°C (32°F to 104°F)

Storage ................ –10°C to 30°C (14°F to 86°F)

●

Recharging time is based on room temperature of

20°C (68°F.)

●

The lower the temperature, the longer recharging

takes.

Cassettes
To properly use and store your cassettes, be sure to
read the following cautions:
1.During use . . .
...make sure the cassette bears the VHS-C mark.
...be aware that recording onto prerecorded tapes
automatically erases the previously recorded
video and audio signals.
...make sure the cassette is positioned properly
when inserting.
...do not load and unload the cassette
repeatedly without allowing the tape to run at
all. This slackens the tape and can result in
damage.
...do not open the front tape cover. This exposes
the tape to fingerprints and dust.
2.Store cassettes . . .
...away from heaters or other heat sources.
...out of direct sunlight.
...where they won’t be subject to unnecessary
shock or vibration.
...where they won’t be exposed to strong
magnetic fields (such as those generated by
motors, transformers or magnets).
...vertically, in their original cases.
Terminals