JVC GVT0142-001A manual Operating the TV using the remote control, Setting the manufacturers code

GettingIntroductionstarted

This page is for when operating your TV using the remote control of this product.

Operating the TV using the remote control

Setting the manufacturer's code

1 Slide the remote control mode selector to the TV side.

2 Keep pressing down TV.

NOTE

Keep pressing down TV until Step 4 is complete.

3 Press ENTER.

4 Press number buttons (1-9, 0).

Ex.:

For a Hitachi TV: Press 1, then 0.

For a Toshiba TV: Press 0, then 8.

If there are more than one manufacturer’s codes, try them in turn and select the one that causes the product to work properly.

Manufacturer	Code	Manufacturer	Code
JVC	01	Samsung	12
Hitachi	10	Sanyo	13
Magnavox	02	Sharp	06
Mitsubishi	03	Sony	07
Panasonic	04, 11	Toshiba	08
RCA	05	Zenith	09

NOTE

Manufacturer’s codes may be changed without notice. You may not be able to operate a TV produced by the manufacturer shown above.

5 Release TV.

For TV operation

Operate the remote control by pointing it towards the TV.

Turn ON/OFF the power.

Change channels.

Adjust volume.

9 Select channels.

100+

*1

Alternates between the previously selected channel and the current channel.

Switch TV and video input.

*1 Make sure to slide the remote control mode selector to the TV side in advance.

NOTE

When the batteries are replaced, perform the manufacturer's code setting again.

English

7