Advanced operations
35
IMPORTANT
Before using the remote control for the following
operation;
• Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
• There is a time limit when doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
1Press SETTING.
Example:
2Press Cursor Y/5 to select the item

you want to set.

• DEC (Decode):
When you play an external source (DBS is selected as a
source) that was encoded with Dolby D or DTS Digital
Surround, the following symptoms may occur;
• No sound comes out at the beginning of playback.
• Noise comes out while searching for or skipping chapters
or tracks.
A/PCM (Auto/PCM):
Normally select this. The system automatically
detects the incoming signals.
DD: Select this if the symptoms above occur when
playing a disc (or software) encoded with Dolby
D.
DTS: Select this if the symptoms above occur when
playing a disc (or software) encoded with DTS
Digital Surround.
VIDEO: To watch DVD playback via the VIDEO jack.
S: To watch DVD playback via the S-VIDEO jack.
COMP (Component):
To watch DVD playback via the COMPONENT
VIDEO OUT jacks.
• MON (Monitor Out):
Select the video output jack type by which you watch DVD
playback after connecting your TV. (Apg. 11)
Set the video output to use AV COMPU LINK remote
control system. (Apg. 41)
VIDEO: To watch DVD playback via the VIDEO jack.
S: To watch DVD playback via the S-VIDEO jack.
COMP (Component):
To watch DVD playback via the COMPONENT
VIDEO OUT jacks.
3Press Cursor 3/2 to make an

adjustment or selection.

Example:
The adjustment is set and the display automatically disappears
a few seconds later.
NOTE
• When “DD” or “DTS” is selected, if a signal encoded with another
digital format comes in, you cannot listen to the sound. (The
GDIGITAL or C indicator flashes.)

Sound and other settings

A
E
D/M
C. C
P
E
DDD
C.
See page 24 for button locations.
TH-C3C6[UJ].book Page 35 Monday, April 4, 2005 6:56 PM